Configuring a DS-System replication group
Each DS-System in a replication group must know the IP address of the other DS-Systems in the group. This configuration can be performed once from a single DS-Operator connected to any of the DS-Systems.
To configure a DS-System replication group:
1. On the Setup menu, point to DS-System Group, and then click Configuration.
2. In the DS-System group configurations dialog box, do one of the following:
• To add DS-System, click Add.
• To modify a DS-System, select the IP address of the DS-System, and then click Modify.
NOTE: To delete a DS-System, select the IP address of the DS-System, and then click Delete.
3. In the Add/Modify DS-System address dialog box, do one of the following:
• To add a single DS-System, select Single System, and then enter the IP address of the DS-System.
• To add an N+1 DS-System, select N+1 System, and then click Add. In the New DS-System address dialog box, select Single IP or IP Range, type the required IP address, and then click OK.
NOTE: When configuring a DS-System group for the first time, select the Local DS-System option and enter the IP address of the DS-System that is currently connected to the DS-Operator. Then continue with configuring other DS-Systems.
4. Select the replication bandwidth of the DS-System. Your options are as follows:
• Unlimited – The backup or restore bandwidth is not limited to any value.
• Limited to ... KB/sec – The backup or restore bandwidth is limited to the specified value.
5. Click OK. Continue until you have completed the list of DS-Systems in the replication group.
6. Click Apply.